Bearings,as important components in contemporary mechanical equipment,mainly support the mechanical rotating body,which can reduce the friction coefficient during its movement and ensure its rotation accuracy.
4246793 bearings are used in the Excavator Final drive system of Hitachi ：
4246793 BRG.;ROL. Hitachi parts CHR70, CX350DR, CX500, CX500DR, CX500PD, CX550, CX700, CX700 JPN, EX200-2, EX200-3, EX200-3C, EX200-3E, EX200-5, EX200-5 JPN, EX200-5HG, EX200-5HHE, EX200-5LV JAP, EX200-5X JPN, EX200-5Z
working under the toughest working
environment
able to work under high temperature,
water, particles
one-stop rolling mill solution to reduce
rolling mill’s cost
ready stock delivered within 7days
OEM service
UCPH bearing is a type of bearing unit. This bearing unit is also a combination of PH bearing housing and pillow block bearing. UCPH bearing seat is much higher than other types of bearing housing, mainly used in special installation environment. The bearing housing is mainly made of cast iron, and stainless steel and plastic materials are used less than cast iron. The pillow block bearing is the same with the other types of mounted bearings unit.
206KPP4 Agriculture Bearing with Chrome Steel material ,Hex Bore, Two Triple Lip Seals, the dimensions is 1" ID, 2.4409" Cylindrical OD, 0.6299" Inner Ring Width, 1.0600".
MR106ZZ Miniature Shielded Bearing 6mm x 10mm x 3mm, the inner diameter is 6mm, outer diameter is 10mm and the width is 3mm, Bearing is made of Chrome Steel, each bearing has 2 Metal Sheilds to protect the bearing from dust or any possible contamination, also bearing is pre-lubricated with grease.
6202ZZ (15x35x11mm) is a single-row bearing that supports radial loads, made with Chromium Steel providing superior quality and durability. It comes pre-lubricated and shielded to keep the lubricant in and contaminants, dirt and debris out.
Proper amount of lubricant is not required to be cleaned before installation, and lubricant is not required to be added. When the jacking screw on the protruding end of the bearing inner ring is fastened on the shaft, the allowable axial load shall not exceed 20% of the rated dynamic load.
All bearings are available in 52100 Chrome Steel or 440 Stainless Steel. Bearings also available with single shield or seal: suffix Z, RS, RU or TS. TTS is used smaller ball, load rating is lower than standard.
