Bearings,as important components in contemporary mechanical equipment,mainly support the mechanical rotating body,which can reduce the friction coefficient during its movement and ensure its rotation accuracy.
F626ZZ bearing is a flanged ball bearing made of chrome steel in which the bearing is metal shield from both sides It has an 6mm inner diameter, a 19mm outer diameter, a 6mm thickness, and an 22mm flange.
XKAY-00387 bearings are used in the final drive Bearing system of HYUNDAI heavy machinery equipment：
XKAY-00387 HYUNDAI BEARING parts
Apply to R55-7, R55-7A, R55-9, R55-9A, R55-9S, R60CR-9, R60CR-9A, R80-7, R80-7A, R80CR-9, R80CR-9A, RD80-7
4246793 bearings are used in the Excavator Final drive system of Hitachi ：
4246793 BRG.;ROL. Hitachi parts CHR70, CX350DR, CX500, CX500DR, CX500PD, CX550, CX700, CX700 JPN, EX200-2, EX200-3, EX200-3C, EX200-3E, EX200-5, EX200-5 JPN, EX200-5HG, EX200-5HHE, EX200-5LV JAP, EX200-5X JPN, EX200-5Z
All bearings are available in 52100 Chrome Steel or 440 Stainless Steel. Bearings also available with single shield or seal: suffix Z, RS, RU or TS. TTS is used smaller ball, load rating is lower than standard.
20Y-27-41260 bearings are used in the Excavator Final drive system of KOMATSU：
20Y-27-41260 BEARING KOMATSU parts： PC160LC-7-E0,PC160LC-8，PC190LC-8,PC200LC-8E0,PC240LC-10,PC210-10
170-09-13220 bearings are used in the Bulldozer Bearing system of Komatsu heavy machinery equipment：
170-09-13220 BEARING KOMATSU parts D150A, D155A, D155C, D155S, D155W
170-09-13220 bearings are used in the Bulldozer Bearing system of Komatsu heavy machinery equipment：
170-09-13220 BEARING KOMATSU parts D150A, D155A, D155C, D155S, D155W
196-4873 bearings are used in the reduction gearbox system of Caterpillar heavy machinery equipment：
1964873 BEARING AS-BALL Caterpillar parts fit:325C LCR, 330C L, 330D, 328D L
The radial and axial clearance can be adjusted during installation and use; The large cone angle mainly bears the axial and radial combined loads, which are mainly axial loads. Generally, it is not used alone to support pure axial loads. When configured in pairs (installed with the same name opposite).
